Bench Pin & Anvil Mount:Clamp

Bench Pin & Anvil Mount:ClampThis bench pin and anvil equips your bench for shaping and forming jewelry tasks. The pin and anvil clamps onto any bench up to 2" thick and has a combination of a milled smooth anvil for shaping and forming, and a replaceable wooden pin to hold sheet or wire in securely place for your detail work.

Tabletop dial speed controls are available with an optional 'LO' and 'HI' settings switch that either restricts or permits complete range of motor speed

Dual temperature settings so you can adjust your solution to your needs

The ball measures 5

doubling as a gravity-feed slab saw and a trim saw by rotating the vise off to one side to free the table for trimming

and other materials and specimens while relieving you of the frustration of a nagging labor-intensive process during your lapping process

allowing you to customize the height of the attached safety hook rod for holding one or two flex shaft motors above your workbench at heights of 24"-40"

The Boxer can be used with all 3 Diamond Pacific Gem-Makers: For the Genie Gem Maker or Titan

and other precision work at your jewelry bench

One edge is safe

115V saws require a 30 Amp circuit and receptacle

A-4914 3 Purple Ceramic Sanding Bands

70/80 mesh ISO 544) good for texturing on all kinds of stones and metals